Springfield Right Tail Light Parts

Springfield Right Tail Light PartsBrackets Machined from a solid bar and then sand blasted to resemble the original sand casting. Available in high strength aluminum bronze alloy or steel. Solder, braze or weld to 1 2" schedule 40 black iron pipe (available locally or below). Three are used per side on most cars very early LHD Springfield's used only two plus a flattened flange in the place of the third at the crossmember location. See lower picture at right. Most cars used a 3rd

This is the ‘Right Stuff’ for Ghosts gearboxes and chassis lubrication-- helps make your Ghost shift like a Ghost

The tech folks at the SGA have reached a special arrangement with a premier oil analysis laboratory

medium or small spring if the complete set is not desired

See the air purging unit elsewhere in this catalog

5 3/4” x 9 1/4”

This is the same unit that is in the SGA faux Westinghouse unit above

See the instrument section elsewhere in this catalog

Other special panel arrangements for single instruments

3" hood riser set of four

Tire Valve covers turned from a high strength aluminum alloy for use with common flat felloe wheels such as Michelin and Warland

Radial Lamp Non-Indexed Straight Pins Part No

SGA replacement grease fitting designed to look like a conventional grease cup but that accepts a modern slide—on grease coupler