Pump Coupler pump coupler

Pump Coupler pump couplerThis coupler is for the model S200 burner (or R200 burner), it couples the burner motor to the pump. There are two sized ends: one is 1 4" for the pump shaft the other is 1 2" for the motor shaft. It also comes with a small prop fan that helps straighten the direction of the combustion air. The S700 burner has a heavy duty coupling that provides the same function.

Otherwise it is the same pump

It is also useful in priming the pump

It is wired to the “CadCell” circuit of the Beckett Primary Combustion Controller

Tanks are not ASME rated

The Air Pressure Gauge provides a reading showing the back pressure between the Nozzle and the Air Regulator

the stainless steel spinner (also called distributor) and an aluminum gasket

There are three models recommended: Model D-3 for BTU sizes up to 300K

It provides the receiving end when using the Burner Harness Quick Connect

INOV8 started using the Delta Solenoid Valve

It is 110/60 electrical and has a range of settings

This wall thermostat accompanies each INOV8 waste oil furnace

The gas-oil burner uses a 3/8" x 5" x 600 watt element